Assembly
1. Replace the auger nose bushing inside the front of the hopper.
2. Install the hopper seal over the flange at the rear of the cooling drum as shown. Ensure that the cooling drum seal is properly seated all the way around the cooling drum.
3. Align the auger shafts with the augers. Push the augers as far as they will go and rotate them so the flat face of the auger shaft is aligned with the flat face of the auger nose. You will feel the auger lock into place with the auger shaft.
4. Install the hopper over the auger and cooling drum and slide it into place. Push down until the hopper lock plunger snaps into place.
5. Set the hopper lid on the hopper with lamp cord at the back.
6. Plug in the hopper lid lamp cord.
7. Position the faucet seal and the return spring in the faucet valve.
8. Slide the faucet valve assembly into place on the hopper.
9. Press down on the valve to compress the spring. Position the faucet handle over the faucet valve one side at a time and snap into place on the hopper.
10. Install the drip tray and cover.
11. Re-attached rear air filter.
12. Turn ON augers and cooling functions to ICE.